QUALITY LIFTS EQ12, Инструкция по установке, эксплуатации и обслуживанию, Страница: 2 / 19

Model EQ12
Installation, Operation and Maintenance
Page 2 EQ12-IOM-Q.
doc
Rev. 2024/03/18
G
ENERAL
S
PECIFICATIONS
* Lift capacity ratings are based on loads equally distributed on all four arms.
** Lifting and lowering speeds may vary depending on the weight of the vehicle.
Fig 1a - General Specifications Fig1b - Service Bay Lay
out
See Figure 1 EQ12
A Rise Height (Screw Pads Highest Position) 75 15/16"
(1928 mm)
B Overall Height 13’-10"/14’-7”
(4216 mm/4445 mm)
C Overall Width 139 3/4"
(3550 mm)
D Drive-Thru Clearance 103"
(2616 mm)
E Floor to Overhead Switch 13’-3 ½"/14’-½”
(4051mm/4280 mm)
F Minimum Arm Reach 35 3/4"
(910 mm)
G Maximum Arm Reach 54 1/2"
(1386 mm)
H Screw Pad Height 4 7/8"
(124mm)
K Inside of Columns 115"
(2921 mm)
Lifting Capacity *
(Hydraulic Pressure at Cap.)
12,000 lbs.
(2600 psi)
Ceiling Height Required 167"/176”
(4242mm/4470mm)
Motor 2HP, Single Phase, 60Hz
Voltage 208-230
Speed of Rise ** 61 seconds
Max Load Per Arm 3000 lbs.
(1360 kg)
Lift Approximate Weight 2150 lbs.