5
3.1 Prior Installation
3.2 Installation
Once the machine has been unpacked, the following steps should be performed:
Check that the electricity supply voltage is the same as that listed on the
specification plate and in the machine’s documentation.
2
4
1
2
1
Installation and Start-up
3.
Verify before Installing:
1. Drainage tube with an interior diameter no less
than 35 mm.
2. Mains water network supply tube connected to
water softener.
3. Stopcock with 3/8” G exit.
4. Grounded plug protected with a magneto-
thermic circuit breaker.
5. Water supply tube (supplied with machine)
from water softener.
6. Drain tube
7. Water softener
1
3
2
4
5
6
7
2
4
1
It is recommended to use water with a hardness
between 5-8 dHº (8-14 fHº), to avoid calcification
and to obtain an optimal quiality of coffee and tea.
i
•
Place the machine on the workbench and
connect the wáter supply from the stopcock (1) ,
to the softener (2).
•
Let the wáter flow to clean it.
1
•
Connect the water supply tube from the outlet
softener to the water inlet of the machine (3).
•
Open the stopcock (1) and check that the
connection is not leaking.
2
•
Open the steam tap.
3
