7
OPErAtiON BY tHE cONtrOl PANEl
The controls are located behind the 2 front covers at the top right and left corners of the insert
and can be accessed by gently pushing the bottom of the covers.
O/I:
Press this switch for main power and flame effect. The indicator light will turn on. See
below for other control instructions.
750w:
For low heat function, press this switch while 0/I switch is in the on position. The
indicator light will turn on.
1500w:
For high heat function, press this switch while 0/I switch and 750W switch are in the
on position for high heat. The indicator light will turn on.
TEMPERATuRE cONTROl:
To adjust the temperature to your individual requirements,
turn the temperature control dial to the right (clockwise) to increase the desired
temperature and to the left for lower temperature. This temperature control dial can only be
used while the O/I switch and 750W & 1500W switches are in the ON position.
dIMMER cONTROl kNOB:
Turn the dimmer dial clockwise or counter clockwise to get
the desired flame intensity. The dimmer switch can only be used when the O/I switch is
in the on position.
NOTE:
When the O/I switch is turned off, all other heater functions will stop even though the
switches may be in the on position.
NOTE:
In order to shut down the heater safely, it is recommended to turn the temperature
control knob to lowest setting and allow the heater to cool down before press the O/I switch to
off position.
MAiNtENANcE
wARNINg:
dIscONNEcT POwER ANd uNPlug ThE POwER cORd BEfORE ATTEMPTINg ANy
MAINTENANcE OR clEANINg TO REducE ThE RIsk Of fIRE, ElEcTRIc shOck OR
dAMAgE TO PERsONs. ThE BulB IN yOuR uNIT cAN BEcOME ExTREMEly hOT.
AllOw AT lEAsT 10 MINuTEs BETwEEN TuRNINg Off ThE uNIT ANd REMOvINg
ThE lIghT BulBs TO AvOId ThE AccIdENTAl BuRNINg Of ThE skIN.
RIsk Of fIRE: dO NOT ExcEEd ThE REcOMMENdEd BulB wATTAgE.
rEPlAciNG tHE FlAME EFFEct liGHt
AND lOG-SEt liGHt BUlBS
Step 1: Remove the 2 screws on the front of the
fireplace and open the glass window.
Step 2: Remove the screws from both sides of
the log set bed.
Step 3: Remove the log set bed. You will find 2 x
40 Watt type E-12 bulbs.
Step 4: Loosen, remove and replace the burnt
out bulb(s).
Step 5: Set the log set bed back into place and
re-attach the screws.
Step 6: Close the glass window and re-attach
the screws.
Step 7: Plug in the unit.
rEPAir SEt
tOUcH-UP rEPAir PAiNt
Paint directly on the mantel unit if necessary.