5
OPErAtiON BY tHE cONtrOl PANEl
The controls are located behind the grill below the front glass and can be accessed
by pulling the grill from the top, forward and down.
WARNING: DO NOT TOUCH. HOT SURFACE AT CENTRE OF GRILL. HANDLE
LEFT OR RIGHT SIDE OF GRILL WHEN PULLING OUT.
O/I:
Press this button for main power and flame effect. The indicator light will turn
on. See below for other control switches.
1250W:
For heat function - Press this switch while the O/I switch is in the ON
position. The indicator light will turn on.
Temperature Control:
To adjust the temperature to your individual requirements,
turn the temperature control dial to the right (clockwise) to increase the desired
temperature and to the left for lower temperature. This temperature control dial can
only be used while the O/I switch and 1250W switch are in the ON position.
Note:
When the O/I switch is turned off, the heater functions will stop even though
the switches may be in the ON position.
MAiNtENANcE
wARNINg: disconnect power and unplug the power cord before attempting
any maintenance or cleaning to reduce the risk of fire, electric shock or
damage to persons. The bulbs in your unit can become extremely hot. Allow
at least 10 minutes between turning off the unit and removing the light bulbs
to avoid the accidental burning of the skin.
wARNINg: do not touch. hot surface at center of grill. hold left or right side of
the grill when pulling out.
RISK OF FIRE: DO NOT ExCEED THE RECOMMENDED BULB WATTAGE.
rEPlAciNG tHE liGHt BUlBS
Step 1: Remove 14 screws on the back of fireplace and open the rear cover.
There are 2 larger screws and 12 smaller screws.
Step 2: You will find 2 x 40W type B-10 bulbs under log-set bed.
Step 3: Loosen and remove the burnt out bulb and replace with new bulb.
Step 4: Close the rear cover. Secure the 2 larger screws into the top left corner hole
and bottom right corner holes as shown in the diagram. Secure the 12
smaller screws into the remaining holes. Make sure the screws are in the
correct holes and have been tightened.
Step 5: Plug in the unit.
rEPAir SEt
tOUcH-UP rEPAir PAiNt
Paint directly on the mantel unit if necessary.
rEPAirS
If any problems are found with the original parts during mantel assembly such as
the panels cannot be installed with the plastic connector. Try to solve by one of the
following method.
Tools required:
Electric drill, drill bits 3/4 inches (10 mm) or 1/16 inches (2 mm),
pencil, hammer, Phillips screwdrivers, safety goggles and gloves (if necessary).
wARNINg: wear goggles before you start drilling.
