7
Step 8: Attach 3 MOUNTING CLIPS [U] onto
the top of INSERT and lock in place with 3
SHORT KD SCREWS [T]. See Fig. H.
Step 9: Install the TOP PANEL [A] to the unit
as shown and attach with 4 KD SCREWS.
See Fig. I.
Step 10: Tighten all KD SCREWS.
Step 11: Carefully move the assembled unit
to the desired location. The Fireplace Mantel
should not be positioned in an area exposed
to direct sunlight.
WALL ANCHOR
SAFETY CABLE
The use of WALL ANCHOR SAFETY CABLE
is highly recommended in order to reduce
the risk of the fireplace being tipped over
accidentally. WARNING: This CABLE may
reduce possible risk of injury if the fireplace
is improperly handled, but is not a substi-
tute for proper adult supervision. Children
should not be left unattended near any
heater.
1. Drill a 5/16in (8 mm) hole in the wall.
Insert the PLASTIC WALL ANCHOR into the
hole and gently tap until the flange on the
anchor is against the wall surface.
2. Position the back edge of the mantel close
to the wall.
3. Attach the SAFETY CABLE to the mantel
using the SCREW FOR MANTLE. See fig. J
4. Use the SCREW FOR WALL to attach the
other end of SAFETY CABLE to the wall.
5. Make sure all screws are tight.
A S S E M B LY I N S T R U C T I O N S
fig. I
fig. G
fig. H