Qualitel Milano CLI, Инструкция по эксплуатации, Страница: 9 / 11

8
¾
Transferring a call between paralleled telephones:
When receiving a call, use one of paralleled telephones to answer. Press “
*
” and the paging
number that was set in the other telephone to transfer the call, the unit rings, pick up its handset or
press key to answer the incoming call.
NOTE: Use the same series telephones for the transfer feature to work. Any special
services starting with “
*
” offered by your service provider may not function properly.
To obtain the best result for this function, you should insert the batteries.
ANTI-DIALING FROM PARALLEL PHONES FUNCTION
1. In the on-hook state, press and hold the # key for 3 seconds, the LCD displays SPI ON
2. Press the key twice and then
3. Press and hold the # key for 3 seconds again, the LCD displays SPI OFF
When the anti-dialing function is set to ON, it will not be possible to make a call from a parallel
telephone plugged into the same line.
SETTING THE RING TONE AND ADJUSTING THE RING VOLUME
There are 16 adjustable ring tones and ringing OFF for selection:
1. In on-hook state, press the RING button, the LCD displays ring 02 db8
2. Press RING to select the desired ring or set ring OFF.
3. Press the UP or DOWN button to set the ring volume.
4. Press SET to confirm and exit.
NOTE: The volume ranges from 1db-8db, with 8db being the loudest. Ring OFF is “ Do Not
Disturb ” mode. If the telephone is set to this mode, the telephone will not ring when there is an
incoming call.
ADJUST HANDSFREE VOLUME
In hands free mode, press UP or DOWN to adjust the handsfree speaker volume, the LCD
displays the volume level and there are a total of 4 adjustable levels.
SELECTING PULSE OR TONE DIALING MODE
1. In on-hook state, press and hold the
*
key for 3 seconds, the LCD displays P , the dialing
mode is set to Pulse.
2. Press key twice, then press and hold the
*
key for 3 seconds again, the LCD displays T ,
the dialing mode is set to Tone.
SETTING PABX CODE
1. In on-hook state, press and hold the DEL button for 3 seconds to set PABX code, the LCD
displays SET PCODE - and the “ - ” flashes.
2. Press the UP or DOWN button to set the PABX code from 0 to 9 or -.