5
6
WARNING
Installers must verify that the supporting surface will safely support the combined
weight of the equipment and all attached hardware and components.
Mounting to a Concrete or a Brick Wall
1b
Using a power drill and a 3/8" masonry drill bit, drill mounting holes of 3/8" (10 mm) diameter
and 2.7" (70 mm) depth at the marked locations in the previous step.
2
ø 10mm
70mm
(2.7")
(ø 3/8")
70mm
(2.7")
Installing the Cable Clip
2
Install cable clip (D) to route cables to the TV as shown in the image and remove bubble level (G).
3 Place concrete anchors (W-B) in each hole. Tap each anchor flush with the wall using a hammer.
Using a socket wrench, mount the wall mount (A) and fasten them with the provided lag bolts
(W-A) and D6 washers (W-C).
Hold the marking template (C) provided against the wall where you want to install the TV,
mark three holes for drilling.
1
C
Marking Template
W-B
W-A
W-C
G
Bubble Level
A
Wall Mount
D
Cable Clip
NOTE
Do NOT use power drill and do NOT over tighten the lag bolts.
Level