Loosen the M6x12mm Screws using the supplied Allen Key (E) until you
can slide the extension brackets freely, as shown.
To suit the mounting hole configuration of your projector, you may need
to replace the attached Extension Brackets with the additional short or
long Extension Brackets (A, B, C, D) supplied in the package.
You can use the supplied
Projector Bracket without additional
extension brackets.
Place the Projector Bracket Assembly over the Projector and align the center of
the Mount with the Center of Gravity of the Projector.
Place the Bottom Spacers (R)
in between the Extension
Brackets and the Projector,
and align the mounting holes
as shown below. If you are
using a short extension bracket
you must use spacer Q.
If your mounting holes are recessed into the projector,
you may need to use the additional Spacers (S, T, U)
supplied in the Hardware Package. Please select the
appropriate Spacer(s) according to the design of your
projector.
Select the correct Mounting
Screws from the Hardware
Package (J, K, L, M,or N) and
firmly screw the Projector
Bracket Assembly onto your
Projector using a Philips
Screwdriver. Once this is
done, the Projector Bracket
Assembly is ready to be
mounted onto the Ceiling
Mount.
7
8
NOTE
Align the shift adjustment opening (at the center of the projector bracket)
in parallel with the projector lens opening to allow shift adjustments to
the projector.
TIP
Extension Bracket
Recessed Mounting Hole
Bottom Spacer Q/R
(For Short Extension Bracket use Q only)
Spacer S/T/U
(Optional: use for Recessed Mounting Hole)
Attaching the Projector Bracket to the Projector
2
I
V
O
P
A/B
C/D
J / K / L / M / N
R
WARNING
If you projector model has three mounting holes only, please remove the fourth
extension bracket using the supplied Allen Key (E).
If your projector model does not have at least three mounting holes, do not use this mount.
E
OR