Qualcast QSPP53, Инструкция по эксплуатации

Страница: 14 / 15

26 27
Note: If you are unsure about performing this operation, call our helpline or go to an
authorised dealer to change the blade for you.
List of consumable parts:
XC92YC Spark plug 974213 Blade
974225 Blade bolt 974008 Mulching plug
1812903 Collection grass bag 916203 Blade washer
1813904 Quick clamp
Parts can be ordered via www.gardenservicecentre.co.uk.
Check the washer is still slightly domed to keep the pressure on the bolt and stop it
unwinding, keeping the blade firmly secure. Then replace the washer (right way around!)
and bolts.
Make sure the blade is correctly located, and then firmly tighten the bolt. Do not over
tighten. The up turn of the blade must project into the motor compartment.
Troubleshooting
WARNING!
Always switch off the engine and pull the ignition cable before starting any
inspection or adjustment work.
If after making an adjustment or repair to the engine you let it run for a few
minutes, remember that the exhaust and other parts will get hot.
The following table provides solutions to common problems encountered with the lawn
mower:
Fault Possible cause Solution
Loud while running,
machine vibrates
heavily
- Screws are loose
- Blade fasteners are loose
- Blade is unbalanced
- Check screws
- Check blade fasteners
- Replace blade
Engine does not
start
- Start/stop bar not pressed
- Spark plug is defective
- Fuel tank is empty
- Engine may be flooded
- Press start/stop bar
- Replace spark plug
- Refill with fuel
- Remove plug and dry, see
page 24
Engine runs
unsteadily
- Air filter is soiled
- Spark plug is soiled
- Clean the air filter
- Clean the spark plug
Uneven mowing
results
- Blade is blunt
- Cutting height is too low
- Sharpen the blade
- Set correct height
Unsatisfactory grass
collection
- Cutting height is too low
- Blade is worn
- Grass bag is clogged
- Set correct height
- Replace the blade
- Empty the grass bag