15
14
Customer Helpline
01904 727500
www.gardenservicecentre.co.uk
Customer Helpline
01904 727500
www.gardenservicecentre.co.uk
Operating the Chainsaw
Step 1 - Start the engine
1a Engage the chain-brake (push it forward until an audible click is heard).
1b Set the switch to the “START” position.
1c Press and release the primer bulb (B) 10 times and ensure that the primer bulb is
approximately 3/4 filled with fuel before attempting to start.
Pull the choke control (A) out to engage.
1d While holding the saw unit securely on the ground, pull the start handle four times. at this
point, the engine will usually not start.
1e Push the choke control in to disengage (failure to do this may cause the engine to flood).
1f Pull the start handle with smooth, continuous pulls no more than five times. If the engine does
not start, remove the spark plug, dry it with paper towel and replace. Repeat the start procedure.
1g Allow the saw to run and warm up in this position for 30 seconds.
1h. Disengage the chain-brake, by pulling it back.
- When restarting immediately after stopping the engine or when the engine is warm, it will not be
necessary to use the choke function.
Make sure the cutting blade is pointing away from your body at all times, the chain may rotate
upon ignition.
NOTE!
If you fail to start your machine or require further assistance, please contact our after
sales support team at 01904 727500 .
Operating the Chainsaw
Step 2 - Checking the oil supply
With the chainsaw fully assembled and adjusted it is important to check the chain oil supply is
dispensing adequate lubrication.
WARNING!
Do not start the engine whilst holding the chainsaw in one hand. The saw chain may touch your
body. This is very dangerous.
Chain oi
l
After starting the engine, run the chain at medium speed and see if chain oil is being dispensed
as shown.
With the chainsaw switched off the chain oil flow can be changed by inserting a screwdriver in
the hole on the bottom of the side of the clutch. Increase or decrease the oil flow according to
your work conditions. Restart the chainsaw and check the rate of flow meets your requirements.
NOTE!
The oil reservoir should become nearly empty by the time fuel is used up. Be sure to refill
the oil reservoir every time when refueling the saw.
Step 3 - Check chain brake
This machine is equipped with a chain-brake that will immediately disable the chain upon the
occurrence of kickback during cutting. The brake is automatically operated by inertia forces,
which act on the weight fitted inside the front guard. This brake can also be operated manually
with the front guard pushed forward to the guide bar. To disengage the chain-brake, pull it back
until it touches the front handle.
a= brake disengage
b= brake engage
Important!
Be sure to test brake operation every time you use the machine and periodically
during the period of use.
a
b
increase
decrease
Chain oil flow
adjusting
1a
1b
1c
1d
switch
A
B
right way of
starting
