Helpline No. UK 0151 649 1500 / IRE 189 094 6244
Helpline No. UK 0151 649 1500 / IRE 189 094 6244
16
6. Remove the start tension cable from the hook
(Fig. 3c). Slacken the wing nuts and fold down the
upper push bar.
7. Wedge a few layers of corrugated cardboard
between the upper and lower push bars and the
engine in order to prevent any chafing.
7.5 Ordering replacement parts
Please quote the following data when ordering
replacement parts:
•
Type of machine HQ-PM48 B&S
•
Article number of the machine 34.007.62
•
Identification number of the machine 11010
•
Replacement part number of the part required
8. Disposal and recycling
The unit is supplied in packaging to prevent its
being damaged in transit. This packaging is raw
material and can therefore be reused or can
be returned to the raw material system.
The unit and its accessories are made of
various types of material, such as metal and
plastic. Defective components must be
disposed of as special waste. Ask your local
council for information.
9. Faults and remedies for faults
Caution:
Always switch off the engine and pull
the ignition cable before starting any inspection or
adjustment work.
Caution:
If, after making an adjustment or repair
to the engine, you let it run for a few minutes,
remember that the exhaust and other parts will
get hot. Thus, do not touch parts that emanate
heat, as these may burn you.
Important.
If problems arise in connection with
the engine, please refer to the enclosed manual
from Briggs & Stratton.
Loud while running, machine
vibrates heavily
- Screws are loose
- Blade fasteners are loose
- Blade is unbalanced
- Check screws
- Check blade fasteners
- Replace blade
FAULT
POSSIBLE CAUSES
REMEDY
Engine does not start
- Brake lever not pressed
- Fuel tank is empty
- Press brake lever
- Refill with fuel
Uneven mowing results
- Blade is blunt
- Cutting height is too low
- Engine speed is too low
- Sharpen the blade
- Set correct height
- Set lever to max.
Unsatisfactory bagging of
the grass
- Engine speed is too low
- Cutting height is too low
- Blade is worn
- Basket is clogged
- Set speed lever to max.
- Set correct height
- Replace the blade
- Empty the collection bag
Notes
