Quadro4Li Manual II: Administrator's Guide
Administrator’s Menus
Quadro4Li; (SW Version 5.2.x)
73
The
Tunnels to Master Devices
page consists of a table where master devices are listed with the corresponding authentication parameters.
Add
functional button leads to the
Add Entry
page where a new master device parameters needs to be provided.
The
Add Entry
page consists of the following components:
The
Enable Registration
checkbox selection is used to enable the registration to the corresponding master device.
The
Tunnel Name
text field requires the SIP tunnel name for
the corresponding connection. System suggests you to start the
SIP tunnel name with the “SIP_Tunnel_” words, according to the
automatic prefix used for the SIP tunnels on the Quadro,
however this is not mandatory.
The
User Name
text field requires the authentication user
name. The field in front of this text field displays the default non-
editable prefix for SIP tunnels: “SIPTunnel_”.
The
Password
text field requires the authentication password.
Please Note:
The
User Name
and
Password
should match
both on master and slave Quadros for the successful SIP tunnel
establishment.
Fig. II-133: SIP Tunnel Settings – Tunnels to Master Devices – Add Entry page
The
Master device IP
text field requires the IP address of the master device.
The
Master device port
text field requires the SIP port number of the master device.
The
Registration State
field displays information whether the slave device is registered on the master or not.
The
Registration Date/Time
field displays the time and the date of last registration on the master’s device.
Call Routing
The
Call Routing
service simplifies the calling procedure for Quadro users, i.e., different types of calls (internal, SIP, PSTN or IP-PSTN) can be
placed in the same way. SIP registration is not needed for extensions to make routing calls.
The
Call Routing
page offers the following components:
When the
Route all incoming SIP calls to Call Routing
checkbox is disabled, for all incoming SIP calls Quadro will first search the incoming SIP
table. If found, the incoming SIP call will ring on the corresponding extension. If not found, Quadro will look
for a matching routing rule in
When the
Route all incoming SIP calls to Call Routing
checkbox is enabled, for all incoming SIP calls Quadro will
directly look for a matching routing rule in
table and
will ignore the possible matches in the
table.
The
Call
Routing Table
link leads to the
Call
Routing
table
where routing patterns may be manually defined.
The
Local AAA Table
link leads to the page where local AAA
(Authentication, Authorization, and Accounting) database can be
managed.
Fig. II-134: Call Routing page
