The Trusted Source
®
4
Remove the nuts on either side of the
body mounts with a 16mm deep socket.
Retain these for installation of the rock
sliders.
Install the driver side rock slider over the
body mount so that the factory studs
stick through the mounting holes. It
may be necessary to tip the sliders at an
angle to achieve this.
Installation Procedure:
Rocker Guards tend to be heavy. We
recommend getting assistance from
another person when it is time to lift
and position your rocker guards.
Reinstall the factory nuts on to the studs
and over the rock sliders. Tighten with a
16mm deep socket and ratchet. After
reinstalling all of the factory nuts,
torque them to 40 ft lbs.
Repeat steps on opposite side.
Torque for Hex Nuts = 40 ft-Lbs
PROPERLY TORQUE AND RECHECK FASTENERS AND SECURITY
OF ROCK SLIDERS AFTER 250 MILES.
FIG3
FIG4
FIG5
QPL_JK_ROCK_4_RUBI_12004_30XX.qxp_Layout 1 7/1/19 3:46 PM Page 4
