8
NOTE:
Do not completely tighten these straps yet.
T
hey should be holding the top but
not pulled as tight as possible. You will do final “tightening” after you install the
windows.
IMPORTANT: The top deck MUST be centered on the rear of the vehicle for the
windows to fit properly.
NOTICE
FIG 46
FIG 47
FIG 48
FIG 49
FIG 50
FIG 51
Step 6
Continued
: Installing the Top Deck to the Jeep®
With the fabric installed on the
header and
draped over the back of the vehicle, go to the rear
corner of the Top deck and
locate the rear corner
straps. Thread the straps down and under the seat belt mount as
shown in FIGs 46 & 47 and thread the strap through the buckle (Figs 48 & 49).
Repeat this
on the other side of the vehicle and while pulling towards the rear of the vehicle, slightly
tighten one strap and then the other side strap tightening up the top deck. When first
tightening the rear straps notice the location of the rear bar sewn into the pocket on the top
deck. It needs to be centered on the rear roll bar legs
FIG 52
Step 7: Installing the Quarter and
R
ear Windows to the
T
op Deck
To ensure the top is centered on the vehicle you will be installing the two quarter windows and the
rear
window to the top deck and to each other
before securing it to the vehicle body.
Pro-Install TIP: To make
this as easy as possible,
you may have to release the front windshield header (release but not un-hook)
and loosen the rear corner straps installed in step
6
. This will allow you to line up all window zippers and
attachments.
The rear corner straps and header will need to be
re-tightened/clamped before using the
top.
Locate the drivers rear quarter window. Line up the driver’s side Quarter window to the zipper on the
deck and zip it as shown in FIG’s 50, 51 & 52
Repeat this on the passenger side of the vehicle.
