Quadra Bigfoot, Руководство пользователя

Страница: 3 / 23

2
Automatic Leveling Control
IF ALL LIGHTS ARE FLASHING, SEE “PROGRAMMING OR ZERO MODE”
Operation:
Vehicle ignition/accessory must be OFF in order to auto level or extend the jacks.
Make sure slide outs are retracted prior to operating leveling system to avoid damaging slide outs.
System is not tied to vehicle parking brake.
Panel will shut off automatically after 5 minutes of no use.
Panel will turn on automatically after ignition is turned on, safety feature to monitor that cylinders are retracted.
1. Turn panel/system on and let system run through its diagnostic mode. Lights will flash clockwise around
the green foot on right side of panel.
2. To Auto level: When the lights stop flashing, simply press the AUTO button once and release. There can
be no movement in the coach during this 60-90 second process, best if operated from outside vehicle or
sitting still inside.
3. If choosing Manual Mode, press and hold the MANUAL button until light comes on. Now each button on
the right will extend the corresponding cylinder. When in the MANUAL mode, each leveler may be
operated individually. FRONT operates right front. RIGHT operates right rear. REAR operates left rear.
LEFT operates left front. When using this feature it is important to level the coach by using two levelers at
a time or small individual increments to avoid twisting the RV body. For example, right front and right
rear, this puts less stress on the frame. To individually retract, press the RETRACT button and the cylinder
button simultaneously. Turn panel off when finished.
4. To retract the levelers: Simply turn the panel on and press and release the RETRACT button. The pump
will shut off when all four cylinders are fully retracted and the ALL UP light comes on. Always do a visual
check to verify all four cylinders are completely retracted. If one or more cylinders are not fully retracted
and the ALL UP light is on, press and hold the EMERGENCY RETRACT button until they are all retracted
and see troubleshooting section to identify what may be going on.
5. The EMERGENCY RETRACT button, this is used to override the electronic safety features built in the
control to retract all four cylinders simultaneously. You will need to press and hold this button until all
four are retracted completely, once released the panel will shut off. As long as there is enough voltage in
the house batteries to turn the motor, this button will retract the cylinders.
CAUTION WHEN OPERATING:
Rear tires must maintain contact
with the ground as the bolt-on
system is not designed for this and
the jacks may shift. Front tires are
typically OK to leave the ground, as
they may need to do so to level.