6
01/21
7082-153K
NOTE:
Upon removing the appliance from the fireplace
a tag shall be permanently attached to the fireplace
indicating it has been altered and should be inspected
by a qualified person prior to re-use as a convectional
fireplace (tag included in component pack).
B. Tools And Supplies Needed
Tools and building supplies normally required
for installation, unless installing into an existing
masonry fireplace:
-
Reciprocating Saw
-
Channel Locks
-
Hammer
-
Phillips Screwdriver
-
Tape Measure
-
Plumb Line
-
1/4” Self-Tapping Screws
-
Framing Material
-
Hi-temp Caulking Material
-
Gloves
-
Safety Glasses
-
Framing Square
-
Electric Drill & Bits (1/4”)
-
Level
May also need:
Vent Support Straps
Venting Paint
Risk of Fire!
•
Damaged parts could impair safe operation.
•
Do NOT install damaged, incomplete or
substitute components.
C. Inspect Appliance and Components
• Open the appliance and remove all the parts and articles
packed inside the Component Pack. Inspect all the parts
and glass for shipping damage.
• Report to your dealer any parts damaged in shipment.
• All labels have been removed from the glass door.
• Plated surfaces have been wiped clean with a soft cloth,
if applicable.
• Read all the instructions before starting the
installation. Follow these instructions carefully
during the installation to ensure maximum safety
and benefit.
• Follow pipe manufacturer instructions for installation
and air clearance requirements.
WARNING
Hearth & Home Technologies disclaims
any responsibility for, and the warranty
will be voided by, the following actions:
•
Installation and use of any damaged appliance.
•
Modification of the appliance.
•
Installation other than as instructed by Hearth & Home
Technologies.
•
Installation and/or use of any component part not
approved by Hearth & Home Technologies.
•
Operating appliance without fully assembling
all components.
•
Operating appliance without legs attached (if supplied
with appliance).
•
Do NOT Over fire
Or any such action that may cause a fire hazard.
WARNING
