Quadra-Fire SANTAFEI-MBK, Руководство по установке, Страница: 19 / 28

May 18, 2015 7019-230C 19
Santa Fe Pellet Insert
Figure 18.1
Grille Bracket Cover
(shipped flat from factory)
Finger bend into position
after grilles are installed
on appliance
Insert heat exchanger rods
through holes on second grille.
Heat Exchanger
Rods
Install bottom 3 grilles before
installing single top grille
Install in flat position
Bend after grilles installed
C. Optional Grille Removal and Installation
Included in Kit: (4) lower grilles; (3) upper grilles, (1)
upper grille; (4) grille bracket covers; fasteners
Tools Required: #2 Phillips head screwdriver
1. Open the door. Remove the top 2 screws on each side
of upper grille and remove the single grille. Remove the
bottom 2 screws on each side and remove the 3 grilles
attached together.
2. Removing the ash drawer before taking off the lower
grille will make the lower grille easier to remove. Using a
Phillips head screwdriver, remove the 2 screws on each
side and pull forward with a downward motion to avoid
catching the grille on the fi repot pull rod.
NOTE: The plated grilles, Nickel, Black Nickel and
Gold, have 4 black grille bracket covers to eliminate
the brightness of the bracket plating. The bracket
covers are shipped fl at, installed on the grilles, and
after the grilles are installed on the appliance they
are then fi nger-bent into position.
4. Attach the 4 grille bracket covers to the lower 4 grilles and
the top 3 grilles. Slip the metal strips through the grille
openings and secure to grille with screws provided. Do
not fi nger bend the cover brackets at this time.
5. Secure the lower grille to the appliance with 2 screws on
each side. Finger bend the bracket covers around the
plated brackets.
6. The upper grille has 2 separate parts. Install the 3 grilles
attached together fi rst. Angle the grilles downward and
insert the heat exchanger cleaning rods through the holes
in the second grille and then twist forward until horizon-
tally level. Attach the grille with only the bottom 2 screws
on each side of grille. Do not fi nger bend the cover brack-
ets at this time.
7. Position the single top grille over the 3 already in place.
Attach with one screw on each side through the top grille
and the other 3 grilles to secure to appliance.
8. Finger bend the bracket covers on the upper grille into
place.
9. Re-install the ash drawer.
D. Door Handle Removal
Tools Required: 5/32 Allen wrench
1. Open the door. Using a 5/32 Allen wrench, loosen set
screw by a couple of turns, but do not remove.
2. Push the pin completely out and remove the handle.
3. Re-install in reverse order.
E. Door Removal
1. Remove the door handle and face. Follow instructions
from D above.
2. The door can now be lifted off the hinges.
3. Re-install in reverse order.