Quadra-Fire • Village Collection Electric Fireplace • 4030-782 Rev D • 11/05
11
5
Heater Preparation
A. Secure and Level the Heater
Shock Risk
Improperly grounded outlets could cause
electrical shock.
•
Always use properly grounded, fused and
polarized outlets.
• Always use ground fault protection where
required by electrical code.
WARNING
Shock Risk
Fire Risk
Improperly protected power cords could cause
electrical shock or fi re.
• Do not pinch the cord or lay against a
sharp object.
•
Do not cover the cord with carpeting, throw
rugs or runners.
•
Arrange and secure cord to avoid a tripping
hazard.
WARNING
Note:
Follow all national and local electrical codes.
Note:
Select a suitable location that is not susceptible
to moisture and is away from drapes, furniture and high
traffi c areas.
Fire Risk
•
Do not
install or operate damaged heater.
•
Do not
modify heater.
• Installation other than as instructed by Hearth & Home
Technologies Inc. is strictly prohibited.
•
Do not
operate the heater without fully assembling all
components.
• Installation and/or use of any component part not
approved by Hearth & Home Technologies.
Hearth & Home Technologies disclaims any responsibility
for, and the warranty and agency listing will be voided by
the above actions.
WARNING
Fire Risk!
• Prevent
contact
with
sagging,
loose
insulation.
• Do NOT install against vapor barriers or
exposed insulation.
WARNING
Nailing Flanges
(both sides)
Figure 5.1
Proper Positioning, Leveling and Securing Heater
The diagram shows how to properly position, level, and se-
cure the heater (see Figure 5.1). Nailing tabs are provided to
secure the heater to the framing members.
• Place the heater into position.
• Level the heater from side to side and front to back.
• Shim the heater as necessary.
• Bend out nailing tabs on each side.
• Keep nailing tabs fl ush with the framing.
• Secure the heater to the framing by using nails or screws
through the nailing tabs.
