January 29, 2014
7036-187
29
MT. VERNON AE INSERT
6
Service Parts Replacement
Baffle
Latches
Insert flat head screw driver into “V”
section and push down and the bottom
of the latch will fall forward off of post
Locating ears - 1 on
each side. Fit behind
bottom edge.
Figure 29.1
A. Baffle Removal
a.
The appliance must be in complete shutdown, com
-
pletely cool and the exhaust blower off
.
b. Open door.
c. The baffle is located at the top inside of firebox.
d.
Remove baffle by placing a flat head screw driver into
the slot of the latches located in the upper corners and
push down. The bottom of the latch will fall forward off
of the post. Lift the baffle up and then out toward you.
Figure 29.1.
e. To replace the baffle, place the 2 locating ears behind the
bottom edge and tilt the baffle up and into place.
f. The baffle must be centered in the firebox before latch
-
ing it in place. If it is not centered the latch is trapped
between the baffle and side of the firebox instead of
latching properly.
g. The bottom of the latches will fit over the posts. Push the
top of the latch forward to lock latch into place.
WARNING
Cast iron is a very heavy material.
The baffle is
made of cast iron and therefore is heavy and awkward
at times to maneuver. Clear and prepare your work
area before you begin.
Remove 4 screws
Glass with Gasket
Metal Bracket
Figure 29.2
• Glass is 5mm thick high temperature heat-re
-
sistant ceramic glass.
• DO NOT REPLACE with any other material.
• Alternate material may shatter and cause
injury.
WARNING
B. Glass Replacement
a. Swing open the face and remove the door from the
appliance by lifting the door off of the hinge pins and lay
on a flat surface face down.
b.
Using a Phillips head screw driver, remove 4 screws, 2
on the top and 2 on the bottom. Remove metal bracket
and then remove the glass.
Figure 29.2.
c. Replace with new glass with gasket.
d. Re-attach metal bracket with 4 screws.
e. Re-install door over hinge pins and close face.
