5700 ACT Wood Stove
Page 18
September 1, 2008
R
250-7090e
Front
Cover
Side Cover
(2)
4 in. Flex Line
(Not Included)
Outside Air Termination Cap
(contains rodent screen)
Flex Flang
e
OUTSIDE AIR kIT INSTALLATION
Front
Cover
Side
Cover
(2)
4 in. (102mm) Flex
Line (Not Included)
Flex
Flange
Outside Air Termination Cap
(Contains rodent Screen)
Fiberglass
Sealing
rope
Cut-away
view
Pedestal Model
Leg Model
Included in kit:
1 front cover; fiberglass rope; 2 vent
straps; venting flange & 4 screws; termination cap
& screws. Not all materials are needed for each
model.
Items Needed for Installation
: 4” (102mm) flex pipe
in the length as required for your installation;
Phillips screwdriver; Silicone sealant; Drills and
saws necessary for cutting holes through the wall
or flooring in your home.
1. remove all materials from packing box.
2. Using a #2 Phillips screwdriver, remove 2 bolts
beneath the ashcatcher. re-use bolts to install front
cover. be certain that the cover is pushed back as
far as possible.
3. Install side covers to each side. Slide covers into
area and secure with 4 sheet metal screws.
4.
Floor installation:
Cut a 4” (102mm) minimum
hole in the floor to accommodate outside air piping.
Use 4” (102mm) metal flex or rigid piping to directly
connect outside air to the unit or into
vented
crawl
space.
(Do not put flex into a non-vented crawl
space)
. Use the supplied termination cap with a
rodent screen. Seal between the floor and the
pipe with silicone to prevent moisture penetration.
Install fiberglass sealing rope under each side of
pedestal.
5.
Rear/wall installation:
Cut a 4” (102mm) hole in
outside wall to accommodate outside air piping.
Use 4” (102mm) metal flex or rigid piping to
directly connect outside air to stove intake. Use
the supplied termination cap with a rodent screen.
Seal between the wall and the pipe with silicone
to prevent moisture penetration. Install fiberglass
sealing rope under each side of pedestal.
FIGURE 18B
FIGURE 18A
