Quadivator HyperCut RD62, Руководство по сборке/эксплуатации/комплектующим

Страница: 24 / 31

6. Troubleshooting Section
Problem Cause Remedy
Discharge chute
plugged
Grass too wet. Wait for grass to dry.
Grass too long. Raise cutting height and cut grass twice.
Cutting too low. Raise cutting height.
Engine RPM too low. Mow at full throttle.
Ground speed too fast. Slow down.
Streaking of
uncut grass
Ground speed too fast. Slow down.
Engine RPM too low. Mow at full throttle, check and reset engine RPM.
Grass too long. Cut grass twice.
Blades dull or damaged. Replace blades or have the blades sharpened.
Debris in the mower deck. Clean mower deck.
Uneven cut Ground speed too fast. Slow down.
Blades dull. Have the blades sharpened.
Blades worn. Replace blades.
Low tire pressure. Add air to correct.
Blades scalping
grass
Cutting height too low. Raise cutting height.
Turning speed too fast. Reduce speed on turns.
Ridges in terrain. Change mowing pattern.
Bent blade(s). Replace blade(s).
Belt Slipping Mower deck plugged. Unplug and clean mower deck.
Debris in pulleys. Clean Pulleys
Worn Belt. Replace Belt
Excessive
vibration Debris in mower decks or in
pulleys.
Clean mower deck and pulleys.
Damaged drive belt. Replace drive belt.
Damaged pulleys. Replace pulleys.
Blades out of balance. Have the blades balanced.
Mower loads
down machine.
Engine RPM too low. Mow at full throttle, check and reset engine RPM.
Ground speed too fast. Slow down.
Debris wrapped around the
mower spindles.
Clean mower.
Mower does not
START
Fuel valve left in OFF position. Turn gasoline valve ON.
Kill Switch cover is not completely
installed Remove the switch cover and lanyard and re-install
on the switch.
Battery level is low or poor! Re-charge or replace the battery.