2212-
37
2
CERTIFICATION
Annex products Pty Ltd, Australia, declares that
the product “OEM Wireless Charger 12V” is in
compliance with RED Directive (2014/53/EU),
EMC Directive (2014/30/EU), CE-LVD Directive (2014/35/
EU) and EN 50498.
The CE certificate of conformity can be found at:
www.quadlock.com.au/compliance
Annex products Pty Ltd, Australia, declares that
the product “OEM Wireless Charger 12V” is in
compliance with the following Directives: Radio
Equipment Regulations 2017, electrical Equipment
(Safety) Regulations 2016 and The Restrictions of the Use
of Certain Hazardous Substances in Electrical and
Electronic Equipment 2012.
The certificate of conformity can be found at:
www.quadlock.com.au/compliance
INDUSTRIE CANADA (IC: 27134-QLO)
IC Caution:
This device contains licence-exempt transmitter(s)
that comply with Innovation, Science and Economic
Development Canada’s licence-exempt RSS(s). Operation
is subject to the following two conditions:
(1) this device may not cause interference,
(2) this device must accept any interference, including
interference that may cause undesired operation of
the device.
RF exposure statement:
This equipment complies with ISED radiation exposure
limits set forth for an uncontrolled environment. This
equipment should be installed and operated with a
minimum distance of 20 cm between the radiator and a
human body.
IC Caution:
L’é
metteur exempt de licence contenu dans le présent
appareil est conforme aux CNR d’Innovation, Sciences
et Développement économique Canada applicables aux
appareils radio exempts de licence. L’exploitation est
autorisée aux deux conditions suivantes :
(1) L’appareil ne doit pas produire de brouillage;
(2) L’appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est
susceptible d’en compromettre le fonctionnement.
Declaration d’exposition RF:
Cet équipement est conforme aux limites d’exposition
aux rayonnements ISED établies pour un environnement
non contrôlé. Cet équipement doit être installé et utilisé
avec une distance minimale de 20 cm entre le radiateur
et un corps humain.
This device complies with part 15 of the FCC
Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired
operation.
NOTE: This equipment has been tested and found
to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation.
This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there
is no guarantee that interference will not occur in a
particular installation.
If this equipment does cause harmful interference to
radio or television reception, which can be determined
by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or
more of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and
receiver.
— Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
— Consult the dealer or an experienced radio/TV
technician for help.
Changes or modifications not expressly approved by the
party responsible for compliance could void the user’s
authority to operate the equipment.
This equipment complies with FCC radiation exposure
limits set forth for an uncontrolled environment. This
equipment should be installed and operated with a
minimum distance of 20 cm between the radiator and a
human body.
