RECOMMENDED FLUID:
For the HZ-3 haze machine we strongly recommend the following fluid which has been
specifically formulated to perform best with any heater-based haze machines.
QTX Ref Code
Description
Size
Results
High quality professional
Haze fluid
High quality ultra
fine mist
160.591UK
5 Litre
SETUP:
1.
Unpack the haze machine
2.
Unscrew the top cap of the tank and remove to fill with the recommended haze fluid
3.
Replace the bottle and screw the cap securely ensuring the pipe is fed down to the
bottom of the bottle so a consistent flow of fluid is supplied to the machine
4.
Connect the remote control
5.
Connect the IEC mains plug and power up
6.
Heat up time is usually between 2-3 minutes. Please ensure no button is pressed
during the heat up time. When the machine is ready the LED light on the machine and
remote control will illuminate
7.
After heat up, pl
ease refer to page 8 “Operation for HZ
-
3”
For your safety, please kindly pay attention to all the warnings listed below:
◼
Always plug in the power last and disconnect from the mains when the device is not in
use or before cleaning
◼
Do not install and operate the unit in rain or extreme heat, moisture or dusty
environments
◼
This unit is for indoor use and dry environments only
◼
Do not switch on immediately but wait until the unit reaches room temperature if it has
been exposed to drastic temperature fluctuations
◼
Do not shake the unit and avoid brute force when installing or operating
◼
Do not use during thunderstorms and please disconnect the power
◼
Do not use solvents or aggressive detergent to clean the unit. Use a soft and clean cloth
Please do not open cover, contains high voltage. This
product is not serviceable or repairable by the end user.
Please refer to qualified personnel for service and repair.
er or professional when unit malfunction.
