152.761UK User Manual
DMX
The fixture is equipped with 3-pin XLR connectors for DMX input and output. The SE
connectors are wired in parallel. Only use a shielded twisted-pair cable designed for 3-pin XLR-
plugs and connectors in order to connect the controller with the fixture or one fixture with
another.
Building a serial DMX-chain:
Caution:
At the last fixture, the DMX-cable has to end with a terminator. Solder a 120 Ohm
resistor between PIN 2 (-) and PIN 3 (+) into a 3-pin XLR-plug and plug it in the DMX-output
of the last fixture.
When in DMX mode there are two channels with the following function:
152.761UK User Manual
INTRODUCTION:
GYRO - RGB LASER
Thank you for purchasing this Gyro laser.
This laser effect moves away from the traditional stepper motor laser patterns of the past,
producing some spectacular gobo effects that rotate at different speeds whilst transforming
into different colours and shapes. The laser is best projected on to a flat surface, such as a
wall or ceiling, or through smoke. Brighter red laser technology allows this effect to produce
much more vibrant colours. Works great as a single unit or as a pair and is an ideal addition to
any lighting rig or for use in permanent installations such as nightclubs or discos.
Unique gobo-like patterns
Brighter 638nm Red laser technology
0.45W total laser power (Red: 100mW, Green 50mW, Blue: 300mW)
Auto, sound-to-light, pattern select and 6 channel DMX modes
Master/slave mode
Easy digital display to set the mode of operation
Key controlled for laser safety
We recommend that this product is used within the guidelines HSG95
