Busker-10U User Manual
FM Tuner
In FM tuner mode, the station frequency (in MHz) will be displayed.
For initial setup, press PLAY/PAUSE to begin the auto-tuning process.
The tuner will seek through all frequencies for strong signal reception (i.e. radio stations)
These will be stored into memory as
,
,
,
… etc.
Stored stations can then be selected using the PREVIOUS or NEXT buttons
Note: Pressing PLAY/PAUSE during auto-tune will allow manual tuning via PREVIOUS/NEXT
Bluetooth™ Connection
Select ‘
’ using the mode button (
7). The Bl
uetooth™
symbol will be flashing if it is NOT
paired with an audio device.
Scan for
Bluetooth™
devices on your phone or other Bluetooth enabled audio player and check
for a device ca
lled ‘Busker
-
pa’.
Select this device and opt to connect your Bluetooth device,
which should then
state that it is connected to “
Busker-pa
” for audio output
.
The
Bluetooth™
symbol on the Busker-10U unit should stop flashing to confirm the
connection.
Play audio from your
Bluetooth™
device and check for output through the Busker-10U unit.
If there is no output, check if there is more than one d
evice within range called “Busker
-pa
”
In the eventuality that more than
one device is called “Busker
-pa
”, try
each device in turn until
the Busker-10U is found. Check also that the volume level is turned up on the sending device.
Once audio is playing through the Busker-10U from Bluetooth, adjust the MEDIA volume
control (7) to the required volume.
Bluetooth on the Busker-10U can only pair to a single device at any one time and should be
operable over a range of 5 to 8 metres.
The tone of the media player and RCA or 3.5mm line inputs can be adjusted using the TREBLE
and BASS controls (14, 15). Cut the treble or bass response by turning the relevant control
anti-clockwise or boost it by turning clockwise.