154.013UK User Manual
DMX operation
In order to access the DMX functions, the DMX start address will need to be set on the
control panel (or from the remote control
–
see below).
When the display sh
ows “
”, this means that the B12P is operated by channels 1
-8 as
detailed on the previous page. When the display shows “
”, this means that the B12P is
operated by channels 203-210.
The start address can be anywhere between 001 and 512
Standalone operation
The B12P can be operated without external control by selecting one of the Auto or custom
static colour settings from the control panel menu. These are Shown in the Internal Settings
section on page 3 of this manual.
Internal settings can also be selected via the included IR remote control as detailed below.
As supplied, the remote handset has a clear plastic tab inserted which should be removed to
activate the CR2025 button cell. Point the handset toward the front of the B12P unit at a
range of no more than 5m for remote control.
Master/slave operation
A B12P fixture operating in one of the standalone modes may be connected onto further
B12P units by DMX lead (XLR-
XLR) as a master unit. The slave units must be set to “IP”
mode to mimic the operation of the master unit.
The LED display will show “IP” followed by two digits, which is the IP number. The IP
number is not used in the B12P and any setting from IP01 to IP64 will operate as slave
mode (IP numbers are only used in different types of fixtures)
When IP mode is selected, the B12P will mimic any DMX input from another B12P operating
in standalone Auto or Static Colour mode.
1 Power on/off
9
Auto 4 sound activated
2 Auto 1 static colours 10 Auto 2 colour change
3 Auto 3 colour fade
11 Auto 5 strobe
4 Static colour -
12 Static
5 Program speed -
13 Program speed +
6 DMX address -
14 DMX a
7 IP slave ID -
15 IP slave ID +
8 IP slave mode select 16 DMX mode select
