Rear Panel:
Setting Up:
1.
Unpack the HZ-1500LED unit.
2.
Unscrew the top cap of the tank and remove to fill with fog fluid.
3.
Replace the bottle and screw the cap securely, making sure that the pipe is fed down
to the bottom of the bottle to ensure a consistent flow of fluid.
4.
Connect the RF remote transmitter to the socket marked
“
Wireless
”
on the rear panel.
5.
If DMX is to be used for control, connect the DMX signal from the controller to the
DMX IN XLR connector. Any further DMX controlled units may be connected via the
DMX OUT XLR connector.
6.
Connect the IEC mains plug and power the unit on.
7.
The unit will begin the warming up process which normally takes around 3-5 minutes.
Operation:
Use the control buttons on the rear panel of the unit to operate the unit
’
s modes and functions
quickly and efficiently as below:
Button
Response
Menu
Scrolls between DMX and LED modes
Up
Increase function or setting
Down
Decrease function or setting
Enter
Enter mode select
