150.456UK User Manual
Operation
The HADRON can operate in stand-alone, master, slave or DMX modes.
Stand-alone
For stand-alone mode, first choose whether sound-to-light is required by selecting
or
from
. Then select one of the eight pre-programmed modes from
option:
- Random show
- Derby, Laser and Strobe fully on
- Derby and Laser 1
- Derby only
- Laser only
- Strobe only
- Derby and Laser 2
- Derby on, Laser/Strobe alternating
- Strobe with laser
Master/slave
Additional HADRON units can be controlled by one master unit allowing synchronisation.
Ensure the master unit slave mode
is set as
and the controlled unit slave mode is
set as
or
. Choose
for same direction movement as master unit and choose
for oppose direction movement. Connect DMX out from the master unit to the DMX in of
the slave unit.
DMX mode
The HADRON can be control by DMX signal, simply connect the DMX signal source to the DMX
in of the unit via a balanced XLR lead. Extra fixtures can be controlled by the same DMX signal
by looping through the DMX out on the HADRON. Ensure the correct DMX start address is set
from the
option on the manual control.
Laser safety function
The laser will only function when the laser safety key switch is turned to the “ON” position.
When in the “OFF” position, the HADRON will only use strobe and derby for all settings. The
remote socket below the key switch serves a similar function; the laser function will be
disabled when the two connections of this socket are connected. To restart the laser function,
the key switch need to be turned off and on again.