QSC Weatherized WideLine Series, Руководство пользователя

Страница: 6 / 16

5 6
Weatherized WideLine Working Load Limits and Design Factors
(Table 1)
lists the suspension components and provides Working Load Limit data at various Design Factors. The tabulated Design Factors are for
static loads only. The choice of which Design Factor to use will depend upon the jurisdiction and venue of installation, as well as the conditions of
suspension. Dynamic conditions are determined by unknown, installation-specific factors and should be referred to a Licensed Structural Engineer for
clarification before proceeding with any suspension of the equipment. The data presented is based upon the listed component weights.
Component Weight 7:1 Design Factor 10:1 Design Factor 12:1 Design Factor
AF3082-wx 11.0 lbs. (5.0 kg) 746 lbs. (338.3 kg) 12 boxes 522 lbs. (236.8 kg) 8 boxes 435 lbs. (197.3 kg) 7 boxes
AF2102-wx 12.5 lbs. (5.7 kg) 514 lbs. (233.1 kg) 5 boxes 360 lbs. (163.3 kg) 3 boxes 300 lbs. (136.1 kg) 3 boxes
– Table 1 –
Suspending the Weatherized Wideline
The WL3082-wx and WL2102-wx are suspended below the AF3082-wx and AF2102-wx Array Frames respectively. The procedures are the same for
each model. The parts necessary for suspension are packaged with the individual loudspeakers. If you are working with both models, be sure to keep
the parts separate. For each model, there are two different length screws,
the screw length for the WL2102-wx is shown in parenthesis.
Bottom Loudspeaker in the Array
1. Start with the bottom loudspeaker assembly on a flat, stable surface, remove the four bolts, associated washers, and hardware from both rear
corners as shown. Place aside for later use.
Note: You can add an Array Frame to the bottom Loudspeaker if needed. Refer to the Assembling the Array Frame section in this document.
– Figure 8 –
e
a
b
c
d
Disassembly
a. M10 Hex Socket Cap Screw
b. M10 Lock Washer
c. M10 Flat Washer
d. Rear Suspension Link
e. Rear-center Suspension Link