13
Mounting the Hand‑held Microphone Models
NOTE!:
The product shall be installed in accordance with the applicable
code requirements. The tripple-gang electrical box must be UL listed, and the dimensions
must meet NEMA standards.
Q-Sys Page Stations are designed to be mounted on a wall or podium with an appropriate cutout and
cavity to allow all cables and power sources to connect to the Page Station rear panel with adequate
stress relief. The included Mounting Bracket is designed to mate with a standard, triple-gang U.S.
electrical box, but does not need one to be mounted. Using an electrical box provides contractors with
the option of pre-wiring, then installing the Page Station at a later time. The Mounting Bracket should be
firmly attached to the wall using the electrical box (if installed) for alignment only.
1. Remove the Mounting Bracket from the Page Station. It is secured by one screw on the bottom of
the Page Station. Refer to
Figure 17 a
. Set the screw aside for later use.
Refer to
Figure 15
.
2. Place the Microphone Strain-relief Clamp
(1)
over the Microphone cable
(2)
.
3. Plug the RJ-45 plug
(3)
into the receptacle
(4)
on the Page Station.
4. Install screw
(5)
through the clamp and into the Page Station to secure the Mic cable.
5. Route all Page Station wiring and connectors through the center of the Mounting
Bracket.
6. Use four tripple-gang screws (included)
(Figure 16-1)
to align and mount the Mounting Bracket to
the triple-gang electrical box if you are using one.
7. Use six screws (not included)
(Figure 16-2)
to secure the Mounting Bracket to the wall. The six
screws shall be appropriate for the surface to which the Page Station is mounted.
IMPORTANT!:
The six screws, securing the Mounting Bracket to the wall, are required
even when using the triple-gang electrical box.
8. Connect all Page Station wiring to the proper connectors on the Page Station.
Refer to "Q-Sys Page Station Rear Panel" on page 9.
Refer to
Figure 17
.
9. Tilt the top of the Page Station back and install the Page Station onto the
Mounting Plate by aligning the two tabs on the Page Station with the two
slots on the Mounting Plate.
10. With the Page Station still tilted, carefully bundle the wiring back into the wall
(or triple-gang electrical box).
11. Push the bottom of the Page Station to the wall.
12. Install and tighten the screw
(Figure 17 1)
removed in step 1, through the
Mounting Bracket up into the Page Station.
NOTE!:
Use these installation instructions to mount the Hand-
held Page Station models to other surfaces as well.
— Figure 15 —
1
1
2
3
4
5
— Figure 16 —
1
2
— Figure 17 —
1
Mounting tabs
on back of
Page Station
