6
Wire the Loudspeakers
Refer to Figure 6.
1. On the top of the enclosure, remove the protective cover for the input connector.
2. Pass the unterminated CAT cable through the protective cover and terminate with an RJ45 connector. Plug the RJ45 connector securely
into the jack.
3. Reinstall the protective cover.
Confirm Connections
1. Once the NL-P4 is connected to a suitable PoE/PoE+ network switch or midspan injector, check the RJ45 jack LEDs for network status.
Left LED
Right LED
Yellow
Green
Dark - Disconnected
Dark - Disconnected/10Mbps/100Mbps
Solid - Link
Solid - 1 Gigabit Link
Flashing - Activity
2. For Q-SYS status check the status LED under the grille (see Figure 7).
Identify
Initializing
Fault
NL-P4
Yellow - Flashing
Blue - Breathing
Red - Breathing
— Figure 7—
RIGHT LED
LEFT LED
STATUS LED
— Figure 6 —
