9
10
Q-Sys™ Core 1000 | Core 3000 | Core 4000 Panel Features
The image below shows the Q-Sys Core 1000, Core 3000 and Core 4000 front panel features for a product having a sample configuration of one blank
I/O Card.
Note that the Q-Sys hardware products are configured at the QSC factory per the customer’s order. At the time of order, the customer specifies the
type of Q-Sys Audio I/O Card to be populated in rear panel audio I/O bay on the Q-Sys Core 1000, Core 3000 and Core 4000 products.
In addition, Q-Sys Audio I/O Card Kits are available for field installation by qualified service personnel.
1
2
3
4
5
6
7 8
9
SD Card Reader Socket
1.
Audio I/O Signal and Card Present Indicators
2.
240 x 64 Monochrome Graphics LCD
3.
Exhaust Vents
4.
Next Page Navigation Button
5.
Device ID Button (locates device in Q-Sys Designer GUI)
6.
Status LED (reports network health, ID and firmware update status)
7.
Power On LED
8.
Clear Settings Paperclip Button (resets network properties)
9.
10. Audio I/O Bay – accepts optional Q-Sys audio I/O cards
11. RS-232 – DE-9 male connector for serial communications
12. Video Out – HD-15 female connector accepts diagnostic
VGA monitor
13. Auxiliary Ports
AUX A Set – USB host connector x2, RJ45 10/100/1000 Mbps Ethernet
•
AUX B Set – USB host connector x2, RJ45 10/100/1000 Mbps Ethernet
•
14. GPIO A and GPIO B – female DA-15 connectors for Q-Sys control I/O
15. Q-Sys Network Port
LAN A – 1000 Mbps only, primary connection to Q-Sys gigabit network
•
LAN B – 1000 Mbps only, backup connection to Q-Sys gigabit network
•
16. Reserved for Future Use
17. AC Main Inlet – IEC male connector
11
12
13
10
14
15
16
17
Front Panel
Rear Panel
Q-Sys™ I/O Frame Panel Features
The images below show the Q-Sys I/O Frame front and rear panel features for a product having a sample configuration of two Mic / Line Input Cards
and two DataPort I/O Cards.
Note that the Q-Sys hardware products are configured at the QSC factory per the customer’s order. At the time of order, the customer specifies the
type of Q-Sys Audio I/O Card to be populated in each of the four rear panel audio I/O bays on the Q-Sys I/O Frame.
In addition, Q-Sys Audio I/O Card Kits are available for field installation by qualified service personnel.
1
2
4
5
6
3
8
7
9
10
11
12
13
Fan Exhaust Vents
1.
Audio I/O Signal and Card Present Indicators
2.
240 x 64 Monochrome Graphics LCD
3.
Next Page Navigation Button
4.
Device ID Button (locates device in GUI)
5.
Reset Network Properties Paperclip Button
6.
Status LED (reports network health, ID and firmware update status)
7.
Power On LED
8.
Configurable Audio I/O Bays
9.
GPIO Interface (control I/O) (see Page 12)
10.
RS-232 Serial Control Interface
11.
Dual Gigabit Network Interfaces for Q-Sys LANs
12.
AC Main Inlet – IEC male connector
13.
Front Panel
Rear Panel
