6
TD-001607-01-A
Passive Mode Connections
WAONN GE:
Do not connect amplifiers directly to the driver inputs! Always use the input terminal strip.
Figure 5 depicts the passive mode connections for the MH-1060X and its companion low-frequency enclosure.
Mode Switch
To set up the loudspeaker system for passive mode, set the mode switch to
PWSSNVT MNDT
. To avoid damaging the loudspeaker system or
amplifier, always make sure the mode switch is in the proper position and the loudspeaker is wired correctly before operating the system.
Input Terminals
The MH-1060X has barrier strip screw terminals that accept up to 6 mm² or #10 AWG stranded loudspeaker wire. Observe proper polarity and use
the largest wire gauge and shortest length that is practical for the application.
In passive-mode operation, apply full-range audio from the amplifier output to the pair of
FALL AW NT N PAO
terminals. The passive
crossover will properly divide the audio spectrum among the loudspeaker drivers.
Output Terminals
The upper terminals labeled
MND
and
HN
are factory-connected to the drivers, so do not connect anything to them for normal operation.
The pair of terminals labeled
PWSSNVT LF NAOPAO
connect to the
N PAO
terminals of the low-frequency loudspeaker enclosure. Use the
wire included or a large-gauge (up to 6 mm² or #10 AWG) and reasonably short pair of stranded copper wire to make the connection. This is the
output of the passive crossover's low-pass output.
NOTE:
Maintain correct polarity at every connection throughout the entire system for optimum performance. Do not connect any
signal to the
MND
and
HN
terminals.
Содержание MH-1060 Series
Страница 7: ...7 TD 001607 01 A Figure 5...
