21
Home Screen Status
Based on the state of the subwoofer hardware, the top bar will show the following colors to verify the status at a glance.
Top Bar
Grey
– There are no errors detected in the system, and the subwoofer is operating properly.
Red
– A hardware failure has been detected. Remove the faulty subwoofer from the system
and run the Diagnostic test (available under the Utilities menu). If necessary, bring the faulty
subwoofer to a QSC Authorized Service Center.
Network Icon
Green
: The subwoofer is connected to a functioning network.
Grey
: The subwoofer has not been connected to a functioning network since it’s last power cycle.
Red
: The subwoofer was previously connected to a functioning network since it’s last power cycle, but it has lost connection to
that network.
Crossover/Low Pass Filter
Blue
: Low Pass Filter is engaged (and current setting is displayed in the icon). 80 Hz is the recommended factory default.
Grey
: Low Pass Filter has been defeated.
NOTE:
HPF can only be defeated when connected to QSC SysNav.
Delay
Blue
: The onboard Architectural Delay is engaged (0-200 ms).
Grey
: The delay has been bypassed.
DEEP
Blue
: The DEEP
™
setting is engaged.
Grey
: The DEEP setting has been defeated.
EQ
Blue
: The Cardioid setting is active.
Grey
: The Cardioid setting has been defeated.
— Figure 17 —
— Figure 18 —
