3
WARNING!:
Two (2) Shackle Adapters MUST be attached to both sides of the Front Strikes, and each pair of shackles
MUST be “mirrored” with one facing forward and one facing backward. Failure to do so could result in physical damage
and/or personal injury.
— Figure 2 —
Attaching Loudspeakers for an Array
1. After attaching the Shackle Adapters and hanging the first loudspeaker of the array, set the loudspeaker’s Locking Levers to the
middle (ADD+) position on both sides.
2. Hang both Front Strikes of the lower loudspeaker onto the Front Hooks of the upper loudspeaker.
3. Lift rear handles of the lower loudspeaker until the Angle Bar connects to the Rear Hooks of the upper loudspeaker on both sides,
making a click sound.
4. Push the Locking Levers down (LOCK) on both sides of the upper loudspeaker.
5. Repeat steps 1-4, for up to a total of three (3) LA112 or four (4) LA108 loudspeakers.
— Figure 3 —
WARNING!:
Do NOT hang more than three (3) LA112 or four (4) LA108 loudspeakers in an array with the LA-KIT-I.
IMPORTANT:
When rigging loudspeakers together, attach the bottom unit to the one above using the QSC
RapidDeploy™ latching mechanism on the upper unit.
WARNING!:
Make sure the loudspeakers are physically, properly aligned; if not, the latching system may not properly
engage, and the loudspeakers could separate causing physical damage and/or personal injury.
WARNING!:
QSC strongly recommends having a dedicated rigging point for each shackle adapter. "Bridling" up to
three (3) LA112 or four (4) LA108 loudspeakers is allowed as long as the angle of the bridle is less than 90 degrees. Using
a single rigging point to bridle between the two shackle adapters in excess of 90 degrees and the allowed number of
loudspeakers could result in damage to or deformation of the front strikes, reducing the safety of the integrated rigging
hardware.
