2
TD-000335-00-C
Rigging KLA181 Loudspeakers Together
1. Insert the supplied 6 mm hex key into the hex socket (
Figure 1, 1
) and make sure the hex key is rotated completely to the Unlock position.
2. Place a KLA181 on top of the fi rst one with the loudspeakers facing the same direction. Make sure that the four feet
(2)
on the top KLA181 nest
properly with the four feet receptacles
(3)
on the top of the bottom KLA181.
NOTE:
The bottom portion of
Figure 2
shows the motion of the hook during the latching process. This is not visible on the
actual hardware.
3. Insert the 6 mm hex key into the hex socket
(1)
in the lower KLA181 and turn the key fully to the
Locked Position
. Repeat for the other side.
a. In the
Retracted Position
, you cannot see the hook in the view holes.
b. When the hook reaches the
Up Position
, the hook almost completely fi lls the large viewing
(2)
hole at the top.
c. In the fi nal, Locked Position, you can see a small portion of the hook in the bottom of the large viewing hole
(2)
.
Using Integrated Suspension Points
NOTE:
The KLA181 suspension points are designed for use with the eyebolts (M10
X 1.50, 35 mm – 38 mm) included in the available accessory kit (model number:
KLA181 M10 KIT).
1. Use a 6 mm hex key to remove the four hex screws from the four KLA181 M10
installation points on the top of the loudspeaker.
2. Thread an eyebolt
(1)
into each of the threaded inserts.
3. Tighten the eyebolts until their shoulders are snug against the enclosure.
4. Continue to rotate the eyebolts until they reach the desired position. Do not overtighten.
5. The loudspeakers are ready for suspension.
— Figure 1 —
1
2
3
— Figure 2 —
Locked
Position
Up
Position
Retracted
Position
2
1
— Figure 3 —
