Attero Tech by QSC
Axiom Product Family
User Manual
QSC, LLC 2020
614-00063
–
AXP2O
–
Device Installation
–
Mounting
A typical installation will involve mounting an Axiom wall plate
into a pre mounted single-gang or larger wall box, standard
drywall bracket or mud ring. Before starting, make sure the wall
box where the Axiom device is to be installed is pre-wired with a
suitable unshielded CAT5/6 cable back to the AXP2O break out
box.
With the AXP2O powered off, attach the CAT cable from the
Axiom port of the AXP2O to the RJ45 on the Axiom device.
Apply power by plugging in the 24V DC power supply to the DC
power input on the AXP2O. The power LED on the AXP2O should
illuminate green. Additionally, the Axiom wall plate should also
start up and become ready to operate.
With the cable attached, carefully place the Axiom wall plate into
the wall box taking care to not trap the cabling. Once fully in
place, secure it with the screws provided. Once the unit is secured
in the wall box, fit the Decora plate over the front of the unit and
secure it with the screws provided with it. It is recommended to
not over-tighten the screws that attach the included Decora wall
plate to prevent cracking it.
*Note:
CAD drawings can be downloaded from the Attero Tech
website. Please contact Attero Tech for any further product
related information that is not accessible on the website.
Figure 18 - AXP2O Dimensional Drawings
