7
TD-000329-01-A
Install the Weather Cover (Optional)
Refer to
Figure 8
1. Slide the nut (1), compression gasket (2), and weather cover / gasket (3) over the
wiring for the loudspeaker.
2. Terminate the wiring to the Euro-style connector, refer to
"Wire the Loudspeaker"
on page 7
3. Install the Euro-style connector.
4. Slide the weather cover/gasket (3) up next to the connection box, use a small
amount of wire, inside the cover, to provide strain relief.
5. Attach the weather cover to the enclosure with four screws (supplied).
6. Slide the compression gasket (2) into the weather cover receptacle.
7. Slide the nut over the weather cover receptacle and tighten.
Wire the Loudspeaker
Use up to 12 gage wiring as appropriate. Refer to
Figure 9
.
1. If you are using the optional weather cover, make sure the wiring is inserted through all three parts of the weather cover in the proper order.
2. Install the negative and positive wires in the "Input" +/- as shown. Tighten the wire-clamp screws.
3. Install the daisy-chaining wires into the "Thru" +/- as shown. These wires go to the next loudspeaker in the daisy-chain.
Remove the Loudspeaker
1. Make sure all the wiring is disconnected, and the safety tether is removed.
2. If the security tab, located at the base of the loudspeaker mount, has NOT been removed, push the tab in and slide the loudspeaker in the
opposite direction of how it was installed.
3. If the security tab has been removed, re-insert it, or use a small rod (<4 mm / 0.16") to push in and release the mount lock.
— Figure 8 —
1
2
3
— Figure 9 —
