6
TD-000329-01-A
Mount the Loudspeaker on the Bracket
Refer to
Figure 6
.
NOTE:
The loudspeaker can be placed on the
mount in ANY direction (Up, Down, Left, Right).
1. Align the "X" slot with the X-Mount™ bracket and push the
loudspeaker onto the bracket. (1)
2. When seated, pull the loudspeaker down to lock the
loudspeaker onto the bracket. (2)
3. (Optional) Remove and retain the security tab (3); pull
straight out. To remove the loudspeaker, re-install the
security tab, press in and then remove the loudspeaker.
Connect a Safety Tether (Not supplied)
WARNING!:
DO NOT connect the tether to
the mounting bracket or the screws holding the
mounting bracket.
1. It is recommended that you connect a safety tether from the
safety ring (4) on the back of the loudspeaker to a spot on
the wall that is structurally suffi cient to hold the weight of
the loudspeaker in the event the loudspeaker should fall.
Suspend the Loudspeaker
Refer to
Figure 7
WARNING!:
Suspend the loudspeaker in accordance with local building codes and
regulations. Use a licensed contractor or professional engineer. QSC Audio Products is not
responsible for damages resulting from the negligent installation suspension cabling or
loudspeaker.
The AcousticDesign loudspeakers (models S8T, S10T and S12) may be suspended using the pull-back point
and M10 eyebolts you install at the bottom of the enclosures.
NOTE:
Suspending the enclosure woofer side up positions the HF closer to the listener
and helps improve bass response when coupled against the ceiling and wall planes.
1. Remove 2 M10 plugs (not shown) from the bottom of the loudspeaker enclosure.
2. Install two M10 -1.5 eyebolts (2) (accessory M10 Kit-C) in the M10 installation points on the bottom of the
loudspeaker enclosure.
3. Attach an appropriate cable to the tether Safety Ring (3) for the pull-back point.
Yoke-mount the Loudspeaker
In addition to the mounting methods listed above, you can mount the loudspeaker using the optional Yoke mounting kit Refer to instructions
provided in the Yoke kit. See the
"Specifi cations" on page 11
for information.
— Figure 6 —
3
1
2
4
— Figure 7 —
2
3
