Host Configuration
103
Table 7-3
Active Sessions Column Descriptions
Column Name
Description
TSIH
TSIH (Target Session Identifying Handle) is used for this active
session.
Initiator Name
It displays the host computer name.
Target Name
It displays the controller name.
InitialR2T
InitialR2T (Initial Ready to Transfer) is used to turn off either the use
of a unidirectional R2T command or the output part of a bidirectional
command. The default value is Yes.
Immed. data (Immediate Data) sets the support for immediate data
between the initiator and the target. Both must be set to the same
setting. The default value is Yes.
MaxDataOutR2T MaxDataOutR2T (Maximum Data Outstanding Ready to Transfer)
determines the maximum number of outstanding ready to transfer
per task. The default value is 1.
MaxDataBurstLen (Maximum Data Burst Length) determines the
maximum SCSI data payload. The default value is 256kb.
DataSeginOrder
DataSeginOrder (Data Sequence in Order) determines if the PDU
(Protocol Data Units) are transferred in continuously non-decreasing
sequence offsets. The default value is Yes.
DataPDU InOrder DataPDU InOrder (Data PDU in Order) determines if the data PDUs
within sequences are to be in order and overlays forbidden. The
default value is Yes.
List Connection Details
Click
▼
->
Connection Details
which will list all connection(s) of the selected session.
Disconnect Session
Click
▼
->
Disconnect
will disconnect the selected session, click the
OK
button to confirm.
Содержание XCubeSAN XS5224D
