Tap this button to enter or exit RIT and XIT. The LCD will show RIT or XIT and the trimming value.
To switch between RIT and XIT, tap the Tuning knob button during trimming mode.
Turning the Tuning knob will trim RX or TX frequencies.
RIT step is 10 Hz and XIT step is 100 Hz.
Press and hold R/T/SPD button for more than 2 sec and it will enter keyer speed setup mode. The
bottom right corner of the LCD will show an arrow of up and down. At this time, release the button and
turn the Tuning knob will change speed. Tap R/T/SPD button to exit speed setup mode and save the new
speed.
(This function is not available for hand key.)
If you keep holding the button after entering keyer speed setup mode for another 1 sec, it will change
MODE to switch between CW and SSB.
Change Tuning Step
Tap Tuning knob and it will switch tuning step among 10 Hz, 100 Hz, 1 kHz and 100 kHz. The small
arrow on the LCD will show the current tuning step.
This function is only valid in VFO mode, not for
MEM.
Auto Scan Mode
In MEM mode, press and hold the Tuning knob for more than 2 sec and it will enter memory auto
scan mode, and it will scan the 16 memorized channels. During the scan, tap M/V/SAV button or R/T/SPD
button and it will change scan direction. In VFO mode, press and hold the Tuning knob for more than 2
