CAI-QLR-01
: QLink Receptacle Customer Assembly Instructions
Page 10 of 11
STRAIN RELIEF ASSEMBLY
BOOT / BEND LIMITER OPTION:
Secure Receptacle in a 4” Drill Press Vise PT-591. Screw Backshell Cover over Spacer. Attach the
Adjustable Crow’s Foot Wrench PT-536 or PT-546 onto Dial Torque-Measuring Wrench PT-506 and torque
per values in Torque Table above. Slide Bend Limiter and Washer into place. Hand tighten Backnut to
Backshell and torque according to the values in the above Torque Table.
WIRE MESH GRIP OPTION:
Secure Receptacle in a 4” Drill Press Vise PT-591. Screw Backshell Cover over Spacer. Attach the
Adjustable Crow’s Foot Wrench PT-536 or PT-546 onto Dial Torque-Measuring Wrench PT-506 and
torque per values in Torque Table above. Slide the two pre-lubricated Square O-Rings and Wire Mesh
Cable Grip into place. Hand tighten Backnut to Backshell and torque according to the values in the above
Torque Table.
.
