Qonnex
39
Quick start 2-Wire v3.0
OER.44 ACCESS
POINT:
Choose 'networks' on your laptop, smartphone or tablet
and if it works well, the list should now say: '2-WIRE-
REL04'.
Select this network.
When asked for a key
(password): '
adminREL04
'.
Automatically your web browser opens and after a
maximum of 1-2 minutes you will be redirected to a
REDIRECT
page where you can then enter the IP settings.
N.B.: If this does not work automatically, surf to 192.168.4.1 (type
in the browser toolbar).
If it does not work immediately, try to pair via
smartphone or tablet and be sure to check the Wi-Fi signal.
Also check if the
COM LED is continuously lit.
REDIRECT PAGE
Once on the redirect page, click on
'Configure
WiFi'
and a list of networks in your vicinity will
appear. You can now select your WiFi network from
the list (SSID), and also enter the password of your
network. After serving, press SAVE and you will
receive the confirmation.
You may need to restart now and REL.44 is now
connected to your WiFi network. You now get an orange LED which
gives a heartbeat every 5 seconds. You can now upgrade by pressing
the JOIN/UPGR button for approx. 5 seconds until the LED is
continuously lit.
4. General remark:
Pre-activate the Belgian digital meters
on the Fluvius website
to open power and data to the P1 port.
If no digital meter or digital meters with DSMR 4.x: then
connect the optional 15VDC power supply.
5.Modbus registers:
REL.44 can be used as a Modbus slave module and can serve as:
Relay module puts 2x 10A/230V in 2x Solid-state relay
P1 port to Modbus interface
Pulse input to Modbus interface
The list of Modbus register can be found on the product page on the
2-Wire website.
6. Technical data:
General:
WiFi network 802.11 b/g/n/e/i (2.4 GHz) , which needs
internet access. Built-in antenna.
Tx pwr:802.11b:+20dBm, 802.11g:+17dBm, 802.11n:+14 dBm
Rx Sensitivity:802.11b: -91 dbm (11 Mbps) 802.11g: -75 dbm
(54 Mbps), 802.11n: -72 dbm (MCS7)
Security: WPA/WPA2, Encryption: WEP/TKIP/AES
Network Protocol: IPv4, TCP/UDP/HTTP/FTP
Built-in time clock daily synchronous with an NTP clock.
2 digital inputs potential-free (pulse or time base)
2 optically isolated pulse outputs max. 24VDC/max 5mA
Connector for external power supply 8-15V/1A
Modbus master of slave configurable
2 bi-stable relay-OFF 10A/230V potential-free, max.2300Watt
ohmic load. Transfer voltage to bus 3kV
16 log channels, 10 days with 5 min.-, 1 year with day
resolution.
Included: 3 meter
RJ12/
6p6c cable (power supply from >DSMR
5)
Operating conditions:
Operating temperature range: 5 °C to 40 °C, indoor mounting
Maximum humidity: 80 %, no condensation, Max.: 2000m
Physical properties:
Housing: plastic, self-extinguishing UL94-V0
Degree of protection: IP20, EN 60529
Dimensions: 2 DIN rail modules ca 75 grams
Quality marks
:
CE : According to EMC and low voltage directive: RE EMC: ETSI
EN 301 489-17 V3.2.4; EMC : EN 61326-1:2013, Safety: EN
61010-1:2010 + A1:2019; RoHS.
7. Installation prescription
The installation must be carried out by an approved installer and in
accordance with the applicable regulations.
During installation, the following must be taken into account (non-
exhaustive list):
- the applicable laws, standards and regulations.
- the state of the art at the time of installation.
- this manual which mentions only general provisions and should be read
in the context of each specific installation.
- the rules of good workmanship.
This manual must be attached to the electrical installation file. On the 2-
Wire website you can always find the most recent manual of the product.
8. Support
Do you want to exchange the product in case of a possible defect? Then
contact your wholesaler or order a "review module" online
.
9. Warranty provisions
The warranty period is two years from the date of delivery. The delivery
date is the invoice date of purchase of the product by the consumer. If no
invoice is available, the production date applies. The consumer is obliged
to inform Qonnex bvba in writing about the lack of conformity, and this at
the latest within two months after discovery. In the event of a lack of
conformity, the consumer is only entitled to a free repair or replacement
of the product, which is determined by Qonnex. Qonnex is not
responsible for a defect or damage as a result of incorrect installation,
improper or negligent use, incorrect operation, transformation of the
product, maintenance in violation of the maintenance instructions or an
external cause such as moisture damage or damage due to overvoltage.
The mandatory provisions in national legislation on the sale of consumer
goods and the protection of consumers in countries where Qonnex sells
directly or through distributors, agents or permanent representatives take
precedence over the above provisions.
Qonnex sprl
B-9310 Aalst,
Belgium
[email protected]
www.2-wire.net
