STEP
2
REMOVE
BATTERY
TABS
STEP
4
CHOOSE
MOUNTING
TYPE
SECURE
ALL
HARDWARE
LEARN
INTO
PANEL
STEP
5
OPEN
DEVICE
CASING
STEP
3
STEP
6
Place your panel in
“autolearn" mode
Open and close the case
to “tamper” the device
Customize name and settings
as desired and and touch “ADD”
ADD
ANGLED
FLAT
ANGLED
CORNER
MOUNT AT
6.5 FEET HIGH
DO NOT USE
THESE MOUNTING
LOCATIONS
Walk test mode is activated by opening the motion detector back plate enough to release the tamper switch, then closing it again. During walk
test mode the red LED on the front of the detector will light up every time motion is detected. Use this feature to test the coverage pattern of
the protected area. The motion detector will remain in walk test mode until there is a period of one minute of inactivity, meaning that no
motion is detected for one minute, at which time it will return to normal mode.
MODES & BEHAVIORS
NORMAL MODE:
Normal mode defines the motion detector’s behavior set in which it can detect motion. It is the default state of the sensor, given no motion has
been detected. While in normal mode, a motion detector sensor can go into both sleep mode and walk test mode, as is described below.
During any given time in normal mode, the motion detector can transmit up to TWO active events. Once the first active event is sent, the
motion detector has a 4 second timeout delay before a second active event can be transmitted. After the first active event is sent, a 5 minute
timer starts; if a second active event is sent during this 5 minute period, the motion detector will go into sleep mode for the remainder of the 5
minute period. Once this 5 minute period times out, the motion detector returns to its normal behavior where it can transmit two active events.
During normal mode, a motion detector will send a supervisory heartbeat to the panel 70 minutes after the last event transmission. If the
device has been idle for 70 minutes consecutively, it will send out a heartbeat supervisory transmission.
Qolsys Inc. proprietary.
Reproduction without permission is not permitted.
SLEEP MODE:
WALK TEST MODE:
Sleep mode defines a limited period when the motion detector does not transmit any active or idle events to the panel in order to conserve
battery life. The sleep mode timer last five minutes and starts once the first active event is sent. During this period, if a second active event is
transmitted, the motion detector will go into sleep mode until the timer finishes counting down.
PET IMMUNITY:
The IQ Motion Detector is pet immune up to 40 lbs when mounted at 6.5 feet high and angled downward. Pets must not be allowed to climb
on objects such as furniture, shelves, boxes, etc. within the field of coverage (see detection pattern on page 3 of this manual). The detector
should not be looking directly at stairs that would allow a pet to walk up them when the panel is armed.
