STEP
2
STEP
4
STEP
5
SECURE
SENSOR &
MAGNET
STEP
6
Document#: IQS-MDW-SQG-02-17
Revision#: 2/24/17
Issue Date: FEB 2017
Qolsys Product #: QS1115-840
APPLY
ADHESIVE
REMOVE
BATTERY
TABS
3/4”
Apply provided
adhesive strips to
the back of
sensor and
magnet.
Magnet gap
should not
exceed 3/4”
STEP
3
LEARN
INTO
PANEL
Place your panel in
“autolearn" mode
Customize name and settings
as desired and and touch “ADD”
ADD
Open and close the case
to “tamper” the device
Magnet locator mark
Magnet
Sensor
LINE UP
SENSOR &
MAGNET
CONTACT TECH SUPPORT
GOT QUESTIONS?
Qolsys Inc. proprietary.
Reproduction without permission is not permitted.
FCC ID: 2ABBZ-RF-MDWS
IC: 11817A-RFMDWS
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired
operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference
that may cause undesired operation of the device.
Cet appareil est conforme avec Industrie Canada exempts de licence standard RSS (s). Son fonctionnement est soumis aux deux conditions suivantes: (1) cet appareil ne doit pas provoquer d'interférences et (2) cet appareil doit accepter toute
interférence, y compris celles pouvant causer un mauvais fonctionnement de l'appareil.
