o
To reattach the clip, slide one side over the center black hub. Using the flat head
screwdriver or you finger, push the clip back over the center hub, opposite of how
you removed it.
o
Reattach the front wheel. Spin the wheel to test if the noise has been eliminated.
Repeat this process and adjust the bend in the clip slightly further if needed.
o
Once the noise is eliminated, re-attach the black hub cap by aligning the two clips
and pushing it into place.
7.
ADJUSTING TENSION IN LOCKING LEVERS:
If you find any of the locking
levers or knuckles becoming loose, you can tighten them as necessary.
o
The top and bottom folding levers are spring loaded with a 13mm bolt, a 13mm nut
on the opposite side, and a 14mm Dome cap nut securing it in place on the outside.
o
The Spine Extension Knuckle is spring loaded with a 14mm bolt, a 13mm nut on the
opposite side and a 14mm Dome cap nut securing it in place on the outside.
o
To adjust, secure the bolt head in place with one wrench, then loosen the dome
cap nut on the opposite side with a second wrench.
o
While still holding the bolt head in place, adjust the nut inside of the dome cap nut
to either tighten it or loosen it to your preferred tension level.
o
Tighten the dome cap nut against the inside nut and you are good to go.
Содержание ELECTRIC GOLF CADDY 2018
Страница 1: ...2018 QOD OPERATING MANUAL...
