QNAP TS-269 Pro, Руководство пользователя программного обеспечения

Страница: 80 / 321

80
This section shows you how to use Linux Open-iSCSI Initiator on Ubuntu to add the
iSCSI target (QNAP NAS) as an extra partition. Before you start to use the iSCSI target
service, make sure you have created an iSCSI target with a LUN on the NAS and
installed the correct iSCSI initiator for your OS.
About Linux O pe n- iSC SI Initia tor
The Linux Open-iSCSI Initiator is a built-in package in Ubuntu 8.04 LTS (or later). You
can connect to an iSCSI volume at a shell prompt with just a few commands. More
information about Ubuntu is available at http://www.ubuntu.com and for information and
download location of Open-iSCSI, please visit: http://www.open-iscsi.org
Us ing Linux O pe n- iSC SI Initia tor
Install the open-iscsi package. The package is also known as the Linux Open-iSCSI
Initiator.
# sudo apt-get install open-iscsi
Now follow the steps below to connect to an iSCSI target (QNAP NAS) with Linux Open-
iSCSI Initiator.
You may need to modify the iscsid.conf for CHAP logon information, such as node.
session.auth.username & node.session.auth.password.
# vi /etc/iscsi/iscsid.conf
Save and close the file, then restart the open-iscsi service.
# /etc/init.d/open-iscsi restart
Discover the iSCSI targets on a specific host (the QNAP NAS in this example), for
example, 10.8.12.31 with default port 3260.
# iscsiadm -m discovery -t sendtargets -p 10.8.12.31:3260
Check the available iSCSI node(s) to connect.
# iscsiadm -m node
** You can delete the node(s) you do not want to connect to when the service is on
with the following command:
# iscsiadm -m node --op delete --targetname THE_TARGET_IQN
Restart open-iscsi to login all the available nodes.
# /etc/init.d/open-iscsi restart
You should be able to see the login message as below: