19
Chapter 3.
Upgrade Memory on QNAP Turbo NAS (RAM Module
Installation)
Warning:
The following instructions should only be performed by an authorized or trained
technician.
Strictly adhere to the instructions in this section to install RAM modules in NAS. Failure
to do so could result in property damage, bodily harm or even death.
Before starting, please ensure that you turn off the NAS, disconnect the power
adaptor, network cable(s), and also remove any other device/cable that is attached to
the NAS.
Please ensure that you wear an antistatic wrist strap during the entire process to
prevent electrostatic discharge. The crocodile clip should be connected to the ground.
When installing more than one memory module, it is recommended to use the same
size and ideally the same type/model in every slot.
QNAP provides RAM modules (optional purchase) for users to upgrade the NAS memory.
Follow the below steps to install an extra memory module on the NAS to upgrade the
memory.
The TS-1685 allows users to upgrade the memory in their QNAP NAS devices. Ensure that
the type of RAM is compatible with the NAS before installing.
To determine how much memory is currently in the system:
1. Log into QTS as administrator.
2. Go to “Control Panel” > “System Settings” > “System Status” to open the System
Status window.
3. To go System Information and check for System memory or Total memory.
