QNAP TES-85U Series, Руководство пользователя по оборудованию

Страница: 14 / 50

14

Reset button: Press to reset the system settings.
System
Basic system reset
(1 beep) Advanced system reset
(2 beeps)
All models 3 sec 10 sec
Basic system reset (3 sec)
Press the reset button for 3 seconds, a beep sound will be heard. The following settings are
reset to default:

System administration password: admin

TCP/IP configuration: Obtain the IP address settings automatically via DHCP

TCP/IP configuration: Disable Jumbo Frame

TCP/IP configuration: If port trunking is enabled (dual LAN models only), the port
trunking mode will be reset to “Active Backup (Failover)”.

System Port: 8080 (system service port)

Security Level: Low (Allow all connections)

VLAN will be disabled.

Service binding: All the NAS services run on all available network interfaces.
Advanced system reset (10 sec)
Press the reset button for 10 seconds; you will hear two beeps at the third and the tenth
seconds. The NAS will reset all the system settings to default as it does by web-based
system reset in “Control Panel” > “System Settings” > “Backup / Restore” > “Restore to
Factory Default” except all the data are reserved. The settings such as the users, user
groups, and the network share folders previously created will be cleared. To retrieve the old
data after the advanced system reset, create the same network share folders on the NAS
and the data will be accessible again.