3. Installation and Configuration
This chapter provides specific hardware and firmware installation and configuration steps.
Hardware Installation
This section provides information on installing drives and expansion units.
Installing M.2 Solid-State Drives
Warning
• Only qualified personnel should perform the following steps. Failure to follow
instructions can result in serious injury or death.
• Observe electrostatic discharge (ESD) procedures to avoid damage to components.
•
Moving fan blades: Keep your hands and other body parts away from moving fan
blades.
•
Other moving components: Keep your hands and other body parts away from other
moving components.
Important
• The TBS-464 has four M.2 SSD slots. For a list of compatible M.2 SSDs, go to
• QNAP recommends installing heatsinks and thermal pads on the M.2 SSD controllers
to enhance cooling efficiency and ensure consistent performance.
1. Power off the device.
2. Disconnect the power cord from the electrical outlet.
3. Disconnect all cables and external attachments.
4. Remove the bottom cover.
a. Turn the NAS upside down.
b. Remove the rubber feet.
c. Remove the screws.
TBS-464 User Guide
Installation and Configuration
11
